Equalizer

A ten-band equalizer that doesn’t clip.

Antify has a built-in 10-band equalizer from 32 Hz to 16 kHz — in the browser, in the Android app and in the programs for Windows and Linux. Try it below without an account; further down you’ll find what it can do and what each band does to the sound.

Equalizer

Hear the difference.

The same 10-band equalizer as in the app — try it here without an account. The demo sound is generated right in your browser.

The demo needs JavaScript to play.

The demo uses the same band frequencies, filter types, range and auto-preamp formula as the app. It shows nine of the 27 presets; the sound is generated synthetically in your browser, nothing is downloaded.

What the equalizer can do

Bands
10 — 32, 64, 125, 250, 500 Hz, 1, 2, 4, 8 and 16 kHz
Range
±12 dB per band, in 0.5 dB steps
Filters
Shelving filters at 32 Hz and 16 kHz, eight peaking filters in between
Preamp
±12 dB manual, plus auto preamp (on by default)
Presets
27 built in, plus your own under a name you choose
Comparison
A/B against the original (key B), reset (R), undo (Ctrl+Z)
Display
Frequency curve of your setting and a live spectrum during playback
Saving
The active curve follows your account to other devices; custom presets are stored on the device and can be exported and imported as a file

Auto preamp: louder isn’t better

Boosting bands makes the signal louder — and a louder signal almost always sounds “better” at first, even when the setting isn’t. Strong boosts can also clip.

Auto preamp therefore lowers the preamp to match the curve: by about 70 % of the largest boost plus a small allowance for neighbouring boosts, rounded to 0.5 dB and by at most 9 dB. Cuts are left alone. A limiter sits at the end of the chain as well. So when you switch A/B, you compare the sound, not just the volume.

The 27 built-in presets

Presets are starting points, not recipes. They cover genres, devices and listening situations — from “Kopfhörer” (headphones) and “Handy-Lautsprecher” (phone speaker) to “Night” for quiet listening and “Podcast / Stimme” (voice). Save your own setting under a name of your choice; it then appears in the list under “Eigene” (custom). Preset names are shown as they appear in the app, which is in German.

  • Flat
  • Bass Boost
  • Cloud Rap 808
  • Trap
  • Drill
  • Vocal Clarity
  • Treble Boost
  • Loudness
  • Night
  • Kopfhörer
  • Handy-Lautsprecher
  • Auto
  • Techno / House
  • Rock
  • Klassik
  • Piano
  • Piano Solo
  • Lo-Fi
  • Podcast / Stimme
  • Bass Cut
  • Slowed + Reverb
  • Slowed Ambient
  • Deutschrap Trap
  • Deutschrap Drill
  • Deutschrap Melodic
  • Deutschrap Bass-Haus
  • Deutschrap Hi-Hat Focus

Which band does what?

The bands are one octave apart. Where things sit in a song depends on the recording — treat the table as orientation, not law.

BandRangeWhat you hear
32 HzSub-bassFelt more than heard: deep 808s, organ, rumble. Small speakers reproduce very little here.
64 HzBassThe push of kick and bassline. Too much of it booms.
125 HzUpper bassFullness and punch. Music gets thick here quickly.
250 HzLow midsWarmth — or mud. A slight cut makes a lot of music clearer.
500 HzMidsBody of voices and instruments; too much sounds hollow or boxy.
1 kHzMidsPresence and intelligibility, nasal when overdone.
2 kHzUpper midsAttack of guitar and snare. The ear is sensitive here — small steps.
4 kHzPresenceCloseness of the voice, definition. Too much turns harsh fast.
8 kHzTrebleCymbals, sibilance (s sounds), detail.
16 kHzAir“Air” above everything. Subtle, and very dependent on headphones and hearing.

Four rules that almost always help

  1. Cut first, then boost. Removing what bothers you needs less boosting — and less headroom.
  2. Work in small steps: 2 to 3 dB is clearly audible. ±12 dB is for exceptions.
  3. Check with A/B. After a few minutes your ear gets used to any setting — comparing with the original brings you back.
  4. Tune for the device, not the song. A curve that corrects your headphones suits every song; per-song recipes need changing all the time.

Equalizer FAQ

Do I need an account to use the equalizer?
Not for the demo on this page. The app itself needs an account — a username and a password are enough, no email address required.
Is the demo the same equalizer as in the app?
It uses the same ten band frequencies, the same filter types, ±12 dB per band and the same auto-preamp formula. Differences: the demo plays a synthetic loop instead of real songs, uses 1 dB steps instead of 0.5 dB and shows nine instead of 27 presets.
Does the setting apply to every song?
Yes. The equalizer sits in the playback path and affects everything Antify plays. The active curve is saved with your account and applied when you sign in on another device.
Does the equalizer work on iPhone?
Yes, while Antify is visible. With the screen locked, iOS plays the audio past the sound processing — equalizer, loudness matching and sound profile then have no effect.
Can the equalizer distort the sound?
Strong boosts can clip. Auto preamp, which lowers the preamp to match the curve, and a limiter at the end of the chain work against that. If you want neither, turn on “Unbearbeiteter Klang” (unprocessed sound) in the playback settings.
What is there besides the ten bands?
In the sound options: stereo width, tilt (bass versus treble, ±6 dB), a channel fix for songs mixed to one side, crossfeed for headphones, loudness for quiet listening and mono output.

The equalizer is part of every account. An account takes a minute: username, password, done.